Trusted Drain Cleaning Services in Castle Rock, CO

The 6-foot panels measure 69.43 inches and the 8-foot railing panel measures 91.31 inches with the post attached. This is very important when installing railing panels to pre-existing structural posts. Be sure that you are measuring the opening.

Our stair panels are produced at a 37-degree angle but can be racked from 28-42 degrees. One additional note: Due to the angle, a 6-foot stair panel will not be long enough for a 6-foot stair run.

These attach kits allow you to attach our panel to a post at either end. Included are 4 deck u-clips and 4 stair u-clips (two for each post/each side) and 16 self-tapping screws.

This kit should be used if you want to attach your railing to either a building or existing posts versus our posts. Wall Mounts are castings and are necessary only if you have a brick wall/uneven surface or lap siding to attach to either/both sides. Note, these are not used often, however, because our system does not have sleeves, cuts must be clean and terminate perfectly to our post or into a flush structure/existing post so as not to see daylight.

Start at one end right at the post and grip the top rail on each side so that your thumbs are parallel to each other and very slowly proceed to apply force every couple of inches. It will be hard to snap on but should work. (Do not use a mallet or bend the top rail as it will cause a dent). The only reason it would not snap on is if you have installed your U-Clips too high whereby one corner surpasses the inside die line of the H-channel. If the latter is the case, remove and reinstall clips so they are below the die line and are straight. Then proceed to snap on the top rail as instructed above.