The Pool Boss›
5.0 147 reviews
“The subcontractors The Pool Boss recommended were just as professional and did outstanding work, making the entire project feel seamless from start to finish.”
FAQs
How many pounds of DE do I add after I backwash?
For a 4820 DE Filter: 4 to 5 pounds of DE are to be added after you backwash your filter For a 6020 DE Filter: 5 to 6 pounds of DE are to be added after you backwash your filter
Why does my filter pressure rise very quickly, even after backwashing?
D.E. filters filter the water down to 1-3 microns, every time the water passes through the filter. Maintain a balanced clear pool and this will reduce incidents of rapid pressure rise. One possibility for a rise is that the filter grids or Flex tubes are clogged with minerals or oils. You should clean your grids once a year, or season, with a degreaser and if needed an acid bath. Minerals and oils embed themselves in the fabric of the filter and reduce the available surface area used for filtering. If too little DE is added during pre-coat, debris and particles will embed in the fabric. Cleaning with a high-pressure hose, NOT A POWER WASHER, may be needed to remove the grids. If cleaning does not work, then replacement is the only option
Why is DE leaking into the pool?
There are only a handful of reasons DE is leaking into the pool. They vary depending on which DE filter you have. If you own a Vertical Grid, check to see if too much DE was added. There might be a tear in the fabric of the grid, or a crack in the top manifold. Or the problem could be a bad o-ring on the standpipe.
Why is there water leaking out of my heat pump?
Most likely your heat pump is leaking water because of condensation. To ensure that condensation is the cause of the leak, take a test strip, and test the leaking water for chlorine. If the test strip shows no chlorine present then the leaking water is condensation from the pump and there is no need to be alarmed or do anything more.
Why is my salt generator is displaying a higher than recommended salt reading?
If your salt generator reading is displaying a higher than recommended salt reading, try to recalibrate your average salt reading, to do this:Turn the system Off and back to AutoPush the Diagnostic button until Instant Salt appears on display (wait until it stabilizes then proceed to the next step)While showing Instant Salt, flip main toggle switch from Auto, up to Super Chlorinate then back to Auto
More info can be found on the FAQ page of our website.
i
