Trusted HVAC Contractors in Goldsboro, NC

Heat Pump Tune Up Replace Filter / Clean If Permanent Disassemble Unit Clean Evaporator and Condenser Coils Remove All Leaves and Debris Tighten All Electrical Connections Measure Amp Draws on compressor, Motors and Heat Strips Inspect Outdoor Fan Blade Clean and Adjust Blower Wheel if Needed Clean and Inspect Flow of Condensate Drain Inspect and Test Defrost Cycle Inspect Crank Case Heater Test Capacitors Reassemble Unit, Replace Any Missing or Rusted Screws Wash Unit and Apply Protective Coating Monitor and Record Delta T Inspect Duct System Monitor Air Flow Inspect Thermostat and Reset to Customer Desire Settings Cycle System to Ensure Proper Operation Gas Heating Tune Up Replace Filter / Clean If Permanent Disassemble Unit Clean and Adjust Burner Assembly On Inshot Burners, Clean Between Carryovers and Align Inspect Heat Exchanger Inspect and Clean Combustion Blower Assembly Inspect Ignitor and Pilot Assembly Clean Pressure Switch Hose Monitor Gas Pressures Inspect Gas Piping / Connections for Leaks Test Safeties / Monitor Flue Clean Evaporator and Condenser Coils Remove All Leaves and Debris Inspect Outdoor Fan Blade Clean and Adjust Blower Wheel if Needed Clean and Inspect Flow of Condensate Drain Test Capacitors Reassemble Unit, Replace any Missing or Rusted Screws Wash Unit and Apply Protective Coating Monitor and Record Delta T Inspect Duct System Monitor Air Flow Inspect Thermostat and Reset To Customer Desire Settings Cycle System to Ensure Proper Operation...